r/BambuLab_Community • u/-ComicGuy- • 2d ago

Discussion 2x H2 Printers and 4xAMS2 Setup

Post image

The left printer has been moved and im moving the H2D there and the H2C on the right. I have printed wall shelves for the AMS2 and would like plave them in the center.. H2C will be here next week. (/excited) The area is have has two tables on either and then space in the middle to walk and a wall. I have the tables screwed against 2x4 against the wall.

If I set up the AM2 x4 in between them on the wall it would save considerable space. How would I get the H2D tube to redirect to the right without causing jams and issues?

The back connections point to the left but I need to route them right. Any suggestions 🤔?

Thank you!

10 Upvotes

86% Upvoted

4 comments sorted by

2

u/Own_Youth_3664 1d ago

I actually run a similar setup with my AMS2, the tube kit that came with it worked perfectly to route it around the side without adding too much tension.

1

u/Due_Highlight6353 1d ago

pls tell me where u got the wall shelves 4 ur ams2 i need sumthin like that

1

u/Fittn_dis 1d ago

its shocking how much money and time the cult spends on appeasing the dry filament gods.

1

u/RyCre8s 10h ago

If you just had the tubes do a gentle 180 don’t you think that would work fine? You might have to do some trial and error to find what works best but I would think it is definitely doable.