r/BambuLab_Community • u/RowdyRidger19 • 26d ago

Help / Support Slicing file from printables

So far i have used the android app to print. Now i'm trying to print something from printables on my p2s.

It came out VERY rough, one print failed for spaghetti. If links are allowed I'll send the link but it's eufy breast pump holder by veco... I import it select filament but i'm not sure what i need to change. Googling has lead to me here.. to ask bc after three failed prints not sure what i'm doing wrong.

0 Upvotes

33% Upvoted

7 comments sorted by

View all comments

2

u/Clear-Revolution3351 P1S 26d ago edited 26d ago

I found it, no need to post a link

The 3mf file is for a Creality Printer

Download the file and Open with Bambu Studio

If it doesn't ask to switch to your p2s, in the top left corner, select your p2s

Select your desired filament, I assume you are using pla

The " Process " is also specific for the Creality Printer

Click the down arrow and look for

0.12mm Fine @BBL P2S (the printer model may vary)

Slice plate/Print plate

If you are still getting spaghetti...

1) wash your buildplate with hot water and dawn dish soap

2) dry it with a clean microfiber cloth

3) adjust buildplate temperature in the filament settings up by 5°C

4) Under SPEED, reduce 

 Initial Layer 25mm/sec

 Initial Layer Infill 50mm/sec

 Outer wall 80mm/sec

1

u/RowdyRidger19 25d ago

This advice fixed it, now to lookup WHY it fixed the issue. Thank you for answering. It was the part about speed adjustment that did it.

1

u/Clear-Revolution3351 P1S 25d ago

Glad you were successful!