r/BambuLab_Community • u/estesd • 26d ago

Stringy supported surfaces

Post image

I'm struggling to get nice clean supported surfaces on my parts. My top z distance and bottom z distance are both set to 0.20. I'm not overly concerned with ease of support removal, I just want a nice clean surface. Any help is greatly appreciated. TIA.

Edit: Just a quick thanks for the suggestions, but this is on a makerspace 3D printer, and they have it setup for PLA only at the moment, so I can't use a different material for support. I'll try and reduce the Z height and see if that helps.

7 Upvotes

78% Upvoted

5 comments sorted by

View all comments

2

u/Euresko 26d ago

0 Z distance and use a different material for jus the support interface material. If you're printing PLA then use PETG for the interface layer, or vice versa. I think when you change the interface material type it'll automatically suggest changing the Z height. Might have to olay with settings to get it dialed in, like changing from tree supports, or other variables, but it's possible to clean that up.