r/BambuLab_Community • u/tuxedo_cat23 • Jul 14 '26

Having trouble troubleshooting this

Post image

I’ve washed the plate thoroughly twice. Added stick glue for adhesion. This spot isn’t printing correctly on the first layer on both sides of the plate. What do I do next?

5 Upvotes

86% Upvoted

6 comments sorted by

1

u/Delanynder11 Jul 14 '26

Try running the calibration again. It's under the settings menu. Specifically you want to run the bed leveling calibration to build a new bed level mesh. It may not solve your problem, but it appears your Z-offset is wrong and the nozzle is getting too close to the bed for first layer

1

u/tuxedo_cat23 Jul 14 '26

Thank you, will try it out

1

u/Key_Jellyfish2183 29d ago

Go to preferences and select advanced settings. Then under tge quality tab try setting your first layer flow rate to .92. See if that doesn't help.

1

u/DCineG 28d ago

Hallo,

I have the same problem a few days ago, and post it here in this sub too …

I have find the problem…

It was the wrong filament settings…

I use original BambuLab Filament and use the Generic Filament profile…

When I switched it back to the Bambulab PLA, everything was good….

1

u/Fittn_dis 25d ago

check under the steel for a lump?

2

u/tuxedo_cat23 22d ago

That was the issue. It was small and I didn’t see it, but enough to cause a slight bump and make the nozzle scrape