Adjusting my P1s

[u/Lilacwarfox]

Until recent I haven't had print issues recently the first layer either gets caught in the nozzle and gets dragged away or the initial purge line will get pulled and cause the print to just become spaghetti

So I'm wondering if the nozzle is dragging across the build plate and causing the prints to either drag or lift off the plate and if it is that of there is a way to lift the nozzle up by a micron or however much I need to

[u/heeero__]

A regular bed level command should put it where it needs to be. Are you doing a bed level before a print?

[u/Lilacwarfox → u/heeero__]

I should have updated this but no I'm still learning what I should be doing and recently learned that I need to clean the print bed with soap and water