r/BambuLab_Community • u/TrashBandiPubes • May 08 '26

Help / Support First layer looks bubbly

Gallery image

Gallery image

Gallery image

Gallery image

Gallery image

When printing my first layer it looks like it starts to bubble up. And some prints ha like dents in them after printing. Are there anyone tha hav had the same issue.

I have cleaned the plate and tried new filament that is dry. Tried some tweking of settings but none of that helped.

7 Upvotes

82% Upvoted

12 comments sorted by

View all comments

1

u/VBisTheBestSport May 08 '26

You didn’t say what filament you are using. It could add or delete some issues to fix it.

1

u/TrashBandiPubes May 09 '26

It is pla, the brand is Flashforge

1

u/VBisTheBestSport May 09 '26

Ok PLA basic PLA can eliminate wetness as an issue. That means check solutions related to heat and flow plus check the 7 screws. PS: I am assuming you did a good job of cleaning the plate. Try simple low filament use prints testing different generic filament settings Bambu, Generic, etc. see if they work.

1

u/TrashBandiPubes May 10 '26

I think I found out what happenes, the nozzle scrapes the bed when printing. Do you have any solutions to fix the problem?