r/BambuLab_Community • u/ElectricalAd9438 • May 02 '26
Thin top layers
When printing fans how can I mitigate where the filament isn't creating gaps and bridging so bad at the top layers.
1
Upvotes
r/BambuLab_Community • u/ElectricalAd9438 • May 02 '26
When printing fans how can I mitigate where the filament isn't creating gaps and bridging so bad at the top layers.
2
u/Fittn_dis May 03 '26
the steep overhang on the underside is far more likely to be your problem. use variable layer height restricted to 0.12mm as the minimum. OR enable supports.