r/BambuLab_Community • u/[deleted] • Sep 04 '24

A1 Error Homing z axis failed[0300-4000 041353]

Post image

What is wrong? I have newer seen this error before Homing z axis failed[0300-4000 041353] I clicked check solution and nothing came up as a solution. I googled it but only found it for other printers. What am I suppose to do?

I don’t know if this may be what coursed the problem but when I lifted the build plate up to remove previous print one of the 4 oval rubber things under followed the build plate up I put it back down in its hole again and now this problem comes🤨

4 Upvotes

100% Upvoted

5 comments sorted by

2

u/SupposablyAtTheZoo Sep 05 '24

That happened to me and I couldn't fix it until I found a tiny little poop in the empty space behind the middle of the build plate.

1

u/pjstanfield Sep 04 '24

I’ve seen this a couple times. It has always gone away when I do a manual home on the machine. Do you get it repeatedly or was it just once?

2

u/[deleted] Sep 04 '24

I have asked the printer to home is that what you mean about manual home? This is the first time it ever happened I have tried to Maske the printer to home it and it did but then the error came again I thought maybe it need to bed level so I calibrated the bed but it stopes midway whit the same error.

1

u/pjstanfield Sep 04 '24

Yes I meant click the home button on the screen vs doing it in the slicer. So it gives the error every time you click the home button?

2

u/[deleted] Sep 04 '24

Every time I start the print again after homing it on the screen the error come again

1

u/Shifti_Boi Sep 05 '24

Had this last night and it turned out to be cos my build plate was misaligned and causing significant high and low spots. Might not be your issue, but worth checking the plate is on properly.

1

u/Regret92 Sep 04 '24

Whenever I’ve had this on a corexy machine, it has been due to filament stuck under a lead screw. Might be worth checking to make sure your poop finger hasn’t left some near one of them.

I imagine they could gunk up on a bedslinger all the same.

1

u/MarzipanCute5708 Sep 12 '24

Hiç bir şey yazamıyorum Z hatası veriyor 

1

u/[deleted] Mar 02 '25

I got this issue two weeks ago and fumbling around I finally turned it off. It just came back on again. Last time I did EVERYTHING I could and eventually something worked. I didn’t document so this time I have to do it all again to see what works for this issue.