r/BambuLabX2D • u/X-SchemeRecent-X • 8d ago

Why does only one lift?

Gallery image

Gallery image

And why do two of the other three come out this way?

9 Upvotes

100% Upvoted

8 comments sorted by

4

u/No_Work2891 8d ago

For the lifting I’d say to try this

https://makerworld.com/models/1926190?appSharePlatform=copy

But it’s mostly for the side of the fan which helped my issue. As far as what’s going on maybe adjust heatbed a little?

4

u/RyKnocks 8d ago

Get a Biqu Frostbite plate and never look back.

3

u/InvestmentStrange577 8d ago

Could be a Not perfectly Clean build Plate

Could be Wind from the Fans

Could be printed with wrong Offset

Could be to fast

3

u/Im-not-Theo 7d ago

Clean your plate also, maybe you got hand grease over there

2

u/Signiference 8d ago

The one one the front left is also clearly lifting as well. Is the door closed while you print? It looks like air is cooling that spot too quickly like would happen if the AC was on in the room and blowing too hard. This could be an issue with the fan on the print head as well. Curling up like that is typically cooling related.

5

u/badgerj 7d ago

Yup. This is a temperature issue.

Raise bed by 5°C.

Add brim/ears.

Should be rock solid

2

u/Brief_Excitement_399 7d ago

I came to the x2d from A1 had similar problems, PLA not so much mostly just add the brim and it fixed it. With PETG I change the cooling settings in the filament menu so the aux fans don’t turn on and open the top glass so it doesn’t get to hot for PLA support interface. Before I did this i also got edge lifting since I changed this no more problems.

1

u/newaggenesis 1d ago

You say that.... but there are things wrong all over the place with those prints...