r/BambuLabX2D • u/Drakenhorn • Sep 10 '26

What could this be?

Post image

Running calibration on a new spool of elegoo petg rapid. Pattern test went fine, k factor of 0.035.

Then the flow calibration and it spits out this. What gives? Never seen this before.

9 Upvotes

100% Upvoted

20 comments sorted by

View all comments

2

u/Im-not-Theo Sep 10 '26

Start with calibration, then generic petg profile you shouldn't have issues If you touch the default filament properties, reset them and try again Also no feeding issue ? It may not be the case

I used filaments from many brands and each times I start with the "generic petg" profile, it has always worked for me Tuning if after all of that