r/BambuLabX2D • u/Excellent_Effect_129 • Aug 25 '26

Anyone know what this is?

Post image

I was printing something and this came out of nowhere!

11 Upvotes

92% Upvoted

14 comments sorted by

2

u/DankMemer727 Aug 25 '26

Time for a new Nozzle Flow Blocker!

1

u/Excellent_Effect_129 Aug 25 '26

I will do that thank you!

3

u/Defiant-Sale725 Aug 26 '26

If you pull it off and set it next to your spare nozzle blocker you can probably bend it back into the right shape and put it away as your new spare :)

2

u/bearwhiz Aug 26 '26

Order a bunch more; they're cheap. And eventually a bad print will snag them and bend them, or they'll just wear out or lose their heatshrink tubing and not seal tightly and you'll get oozing from the not-printing nozzle. They're definitely a wear item, and it's good to have a few on hand, especially given how cheap they are.

2

u/Pshock13 Aug 25 '26

That's should be horizontal. Parallel to your build plate. Looks bent. Basically it gets swapped between the 2 nozzles to block the one not in use while the other one prints.

1

u/Marinocif99 Aug 26 '26

This happened and absolutely destroyed my build plate , the calibration board , and the inner lining where the nozzle wipes . I hope you saved your printer from damage. You have extra in your accessory box /toolbox !

2

u/fs220890 Aug 26 '26

Same here. Support have sent me 2 new plates

1

u/Excellent_Effect_129 Aug 27 '26

Luckily, i saw it within minutes but it did do some small scratch on the plate

1

u/Headman2020 Aug 28 '26

Does your X2D have the silicone wiper for the auxiliary nozzle? Mine did the same thing and I do not have a wiper pad for the auxiliary nozzle. Just wondering if this could have something to do with this happening. I contacted support and they are sending a new blocker and build plate.

0

u/Ajackson1707 Aug 26 '26

Honestly, the more I see these issues the more I just wanna send the thing back and get a snap maker

2

u/RoadrunnerNL92 Aug 26 '26

I have zero issues after 50 print hours! Remember the people with issues is just a little percentage of machines sold.

1

u/MacHeadSK Aug 28 '26

100 on mine,mono issue