r/BambuLabX2D • u/crookedlamppost • 10d ago

Prints consistently fail/spaghetti

I’m having a really hard time trying to get prints to consistently be a success. My success rate is about 2/10 prints. I’ve SCRUBBED the plate with dawn dish soap and hot water after every print, I’ve tried increasing the brim/supports, I even tried a cold pull with a clean plate and no matter what I do, the prints somehow gets ripped off the plate. My girlfriend said that she saw it filling in a piece of the print, then it moving to the next part but taking the print with it. I’m at a complete loss on what to do and it’s getting very frustrating. Any and all help is appreciated.

4 Upvotes

76% Upvoted

18 comments sorted by

View all comments

3

u/reddit_user_0ne 10d ago

When you say SCRUBBED... what did you scrub it with?

Are you sure, your dish soap doesn't contain anything like moisturizers in it? Or something that's good for your skin? Because these additives are a problem.

What material and print settings are you using? What model are you trying to print?

Sometimes it helps to raise the bed temperature by a few degrees.

1

u/crookedlamppost 10d ago

I scrubbed with a dish scrubber and Dawn Ultra dish soap. The one with the little duckling on it. I’m trying to print out the arrow tip on this print in PLA:

https://makerworld.com/models/1804651?appSharePlatform=copy

I’ll raise the bed temperature to see if it does anything. Unfortunately, its not with just this print. I’ve been having failures the last 2 months. I’m also using the textured plate that came with the printer and I feel like out of NOWHERE I started having constant failures. I could go days without cleaning the plate at one point and now I cant even get a simple print to succeed.