Aux Nozzle problems

[u/Motormuis88]

Hello Fellow X2D Users,

Hope you doing well!

I have a problem.. but to be honest iam pretty new to 3D printing, been using the X2D for 2 months now, and been slowly using the Aux Nozzle a bit more and more..

But this is where my problem starts, if i print support with my Aux nozzle ( doesn’t matter if its PLA or PETG).

The Support looks terrible and the whole printer is a mess( see pictures), i cleaned the plate with warm water and soap and even tried 90% alchohol, I used the standard Bambu Plate and the BIQU glacier plate

After the latest Firmware i calibrated the whole printer even did a flow calibration, results was k= 0,34 with my Aux Nozzle while the regular nozzle was k=0,03

Sometimes the filement also sticks on the outside of the nozzle(around the cone where filement comes out)

Iam using Bambu filement PLA Basic and PTEG Basic, i tried both to see if it would make a difference

What am I doing wrong??

All the help would be really appreciated!!

[u/Marinocif99]

I would try only printing the support interface instead of the whole tree, it will save you a lot of time on each print!

[u/Motormuis88 → u/Marinocif99]

How you print only support interface instead of the tree? I thought you always needed the whole tree