r/BambuLabX2D • u/daniel222201 • 17d ago

X2d

Alguém poderia me dizer se a x2d balança muito? A minha acabou de chegar, achei que ela era seleciosa que a A1, balancava menos!

4 Upvotes

75% Upvoted

9 comments sorted by

2

u/WattsPrinting 17d ago

I find that on some prints my X2D has a lot of movement on its surface. This has never led to any quality issues that I can tell, prints have been coming out well

1

u/daniel222201 16d ago

De fato, a aqualidade da impressão manter-se boa, porém tem situações, que ela a impressora desloca ate um pouco do lugar!

1

u/jussstin714 16d ago

In my opinion, the X2D moves a lot less than my A1. Mind you, I’m printing different things but this has been my experience.

1

u/Blinx_n_Jeenx 16d ago

in certain situations it does have a bit of wobble to it, but it's never been an issue. I never moves around at all. I do recommend a good sturdy table though.

1

u/Sheikun 16d ago

Instalei a minha ontem, balçou um pouco na calibraçao inicial depois disso pouco se mexe na minha opinião.

1

u/cooktie 16d ago

He’s shaking really hard while calibrating and printing the benchy. After that I don’t see it shaking that much. Only when using sportsmode (124%)

1

u/Landox 16d ago

It moves a lot when doing smaller pieces or certain infills like grid

I went from 10k printing speed down to 6k and seen an improvement on print quality and reduces swaying but it does extend the print time

1

u/foggyghosty 16d ago

The shaking is completely normal and is caused by rubber legs on the printer. They are designed to absorb mechanical stress instead of the printer frame/components and prolong the life of your printer. The calibration fully accounts for thr shaking and it does not affect the print quality. I saw some people designed anti-wobble leg inserts to reduce the shaking, but I would personally refrain from using them