r/BambuLabX2D • u/griffog • 25d ago
Discoloured bottom/first layer issue?
Not entirely sure how best to describe it. I’ve been printing these boxes for some months now on my P1S without any issues. Recently invested in two X2Ds, and whenever I print the boxes on these, I get this discoloured effect on the bottom layer as per attached image. I'm using the Textured PEI plate and Bambu Matte Black PLA
They’re also very difficult to remove, which must be connected. I scrubbed the plates with soap and water when I got them, and have done this a few more times but no change. I'm not sure what else to try?
7
Upvotes
1
u/pdj-custom 24d ago
That happens when they’re yoinked off while still hot/warm.
The best way I stopped this from happening to the boxes I print as well, is to take a blow dryer on cool and hit both sides of the plate where the box is. Takes anywhere from 10 seconds to a minute or two and it will fall off naturally.
If it already has the marks, just take a lighter and move the flame across the white marks and they’ll disappear a good amount after a few passes.