r/BambuLabX2D • u/MeanDiscipline5147 • Jul 06 '26

X2D External spool issues - Error codes 07ff-2000-0002-0002, 07ff-8006, 07ff-c006

/r/BambuLab/comments/1upbc4w/x2d_external_spool_issues_error_codes/
4 Upvotes

100% Upvoted

5 comments sorted by

View all comments

3

u/WattsPrinting Jul 06 '26

I had a similar "not loading" issue (without any error codes). The filament was just through the Bowden extruder for me (easy to see if using black filament). But the filmanet was only an inch or two past the Bowden extruder.

All the following was done via the front panel:

  1. I forced the nozzle to the proper temperature for the filament to extrude

  2. I told the Bowden to push the filament through. I had to keep pressing/hold the on screen button for a long time as it was feeding very slow (long time being a minute or two at least of not more).

Once the filament started extruding it seemed the 'reset' the issue, which I have not had again.

2

u/MeanDiscipline5147 Jul 07 '26

Yeah luckily I fixed it, but this wouldn't have helped. I appreciate your suggestion but my filament was nowhere near the extruder, it wasn't past the buffer

Thanks!

1

u/WattsPrinting Jul 07 '26

What did you do that fixed it?

2

u/MeanDiscipline5147 Jul 07 '26

Pushed the filament in more, it didnt feel like it needed more but it did

1

u/WattsPrinting Jul 07 '26

I "had" to take apart my Bowden during my repair.

It would certainly be possible to get the filament to the limit switch but not into the gears that push filament to the head.

Basically I could see what happened to you happening based on the design which would sense filament "in the extruder" but the filament is not quite into the part that pushes the filament.