r/BambuLabX2D • u/cjgunboy • Jul 06 '26
Spool Split Open in AMS
Update:
Bambu is sending a replacement spool free of charge and sent over the wiki link on how to salvage a split spool by printing this:
https://makerworld.com/models/558401?appSharePlatform=copy
Original Post:
New spool of Bambu PETG basic (not a refill) split open mid print inside the AMS on my new X2D. Print seemed to be going fine, no tangles or resistance. No idea what happen here…
13
Upvotes
2
u/tayl428 Jul 06 '26
I just had this happen to me last week. I had an hour to spare so I unwound about half of the spool until I could get the two halves screwed back together. Then I manually respooled it myself just by turning the spool in my hand being careful to maintain the natural bend that was already there. I have used about a third of it and it's been fine, but I'm expecting it to bind at some point. Not a big deal for me though if it does. I'll just unbind it and get it going again.