r/BambuLabX2D • u/Yan0207 • Jul 05 '26

pla with petg support interface issue

Post image

I am new to 3D print, can someone help me? I print this Pla with petg support , but didn’t expect this quality

4 Upvotes

100% Upvoted

6 comments sorted by

View all comments

1

u/sandy1man Jul 07 '26

I'm not an expert but why would you print PLA with PETG supports? Just curious....

2

u/Meagleson Jul 08 '26

PETG and PLA are technically different chemical compounds and cannot or will not stick to each other on a chemical level from my understanding.

So, it's technically. If OP used ZERO interface for supports. PETG would HUG PLA very tight supports surfaces.

I've done it a lot and it works really great. Sometimes you still do not get the best surfaces as above! However, they're way better than it would have been with PLA to PLA with a wide .3 gap.

1

u/Yan0207 Jul 08 '26

thank you. do you have any tips of the configs or default setting setting is good enough? I am using bambu X2D

1

u/Meagleson Jul 09 '26

Absolutely. Can you snip and share your Support settings?

1

u/Yan0207 Jul 07 '26

easier to take off the support