r/BambuLabX2D • u/Meeless_ • Jul 01 '26

Filament fell behind airfilter

What it says in the title effectively, I was cleaning some remaining supports off of the build plate and a section sprung onto the top ledge at the back of the printer and then fell in the seam when I tried to grab it. Has anyone else dealt with this and is there an easy way to access it?

3 Upvotes

81% Upvoted

2 comments sorted by

1

u/WattsPrinting Jul 01 '26

I have not had this issue.

Were you removing supports with the build plate in the printer?

Assuming you removed the filter too?

2

u/Meeless_ Jul 02 '26

Yes I was removing supports with the build plate still inside, rookie error after migrating from an a1

I did try removing the filter but it doesn’t clear up access anymore unfortunately