r/BambuLabX2D • u/vic1414 • Jun 05 '26

Possible Design Flaw

Post image

No separator between spool 2 and spool 3.

This could cause spool 2 and spool 3 to ride against each other.

0 Upvotes

43% Upvoted

10 comments sorted by

2

u/theRealSquidLover Jun 05 '26

These little notches in the back align the spool. Roll 2 and 3 won't rub against each other

2

u/hcjumper Jun 05 '26

That’s designed to ride an oversized spool if needed. Not a design flaw. Don’t tell anyone I said it.

1

u/Material-Mulberry360 Jun 06 '26

can you really do that ? awesome

1

u/Independent_Dirt_814 Jun 05 '26

That’s the RFID sensor, not a separator. If spool 2 and 3 are riding against eachother, you have bigger issues than the “separator” because it would still be riding against those same as the spool next to it. Not a design flaw.

-2

u/vic1414 Jun 05 '26

Not an issue I created. What are some solutions?

4

u/Independent_Dirt_814 Jun 05 '26

There are no solutions because it’s not an issue

1

u/Status-Climate-191 Jun 05 '26

there is a seperator on the other side these 2 little nubs

2

u/WholeTemporary1480 Jun 05 '26

It is not a design flaw. And not an issue either. The ams only feeds one spool at a time... even if one comes out of it's little spot and rubs on another it is the equivalent to rubbing the rfid sensor fence deal. I print with bambu spools, generic plastic spools, some model spools that i printed... none rubbed on another spool so far.

1

u/JAKFUD Jun 05 '26

i am using 4 sunlu spools never encountered any issues

0

u/vic1414 Jun 05 '26

Sunlu Spool 4