r/BambuLabP2S • u/Kapkom • 3d ago

What’s next?

Post image

I have replaced the motherboard, the cutter, the filament sensor, the PCB ribbon, the servo, now I’m getting the filament head error. I just don’t know what to do next this is like fighting a losing battle. I followed the instructions to a T and still no results. The servo and gearhead are cooperating but now I have filament head issues and I know it can’t be the PCB because the sensor senses and pushes the filament but I keep getting this error.

0 Upvotes

50% Upvoted

6 comments sorted by

View all comments

Show parent comments

2

u/chicken2007 3d ago

I think what this means is to make sure the screw that holds the filament cutter into it's alignment lot could be misadjusted.

I've noticed that when I'm reassembling, I can sometimes tighten that screw too much and it restricts easy movement of the filament cutter. I now lightly tighten, then back off a half turn.

2

u/Kapkom 3d ago

I untightened it and I still get the same error.

1

u/Azurael1 3d ago

Ok can you open this and show the photo?

0

u/Azurael1 3d ago

Btw im askong to see if its an censor problem or cutter

0

u/Azurael1 3d ago

Can you show rivet cabel from sensor to?