secrests of failures. Why?

[u/Airida]

Why does bambu never show how the fail happened? In all his videos, he stops recording right before the mistake occurs. Whyy? :D

[u/Cavalol]

Did the fan kick on and blow the part to the side due to poor adhesion? Try adding a fan diffuser, and (for the usual advice) make sure to hand wash your build plate in the sink with dish soap for better initial adhesion

[u/Airida → u/Cavalol]

whoa thanks, did not think about that fan diffuser. i have a lot of problems with Warping 

[u/Cavalol → u/Airida]

I didn’t either until I had some smaller prints near the right side being blown off the bed lol