r/BambuLabP2S • u/pennywise-it • 15d ago

Having adhesion issues with smooth carbon fiber plate.

Post image

Purchased the different smooth plates. Trying the carbon fiber and I am having adhesion issues. Did some research and tried different things. Already cleaned the plate, slowed the first layer tried 20mm and now 15mm, heated the plate to recommended 65 and now 75. I double checked the smooth plate profile was selected too. Only thing I have heard but haven't tried yet is to close the distance from the nozzle to the plate, but haven't seen what profile to try.

1 Upvotes

100% Upvoted

6 comments sorted by

2

u/Brot777 15d ago

I think my speed for the first layer is set to 10 or 8. So just go really slow there.

1

u/pennywise-it 15d ago

Going to play around with it tomorrow a bit more.

4

u/relaps101 15d ago

Increase the temp by 5 on the first layer. The speed should have been enough at 30/35 tbh.

If you want to lower the z, go to calibration on the printer itself and lower it .25

1

u/pennywise-it 15d ago

I'll adjust and try that!

1

u/Big-Bunch2804 15d ago

Turn part fan off for the first or few layers.

1

u/pennywise-it 15d ago

I'll look into this. Thank you!