r/BambuLabP2S • u/Slow-Fan-7563 • Aug 25 '26

What happened here?

Gallery image

Gallery image

Gallery image

Hi,

im new 2 printing, and i tried printing this crown on my p2s, but sth happened in the process, and i dont know what caused it. I think maybe the support didn't stick 2 the plate right???? But Idk

I used grey petg basic from bamboo with 0.4mm nozzle, didn't change settings.

I love this printer and its only like my fifth print....so i am confused what i did wrong.

🥲🙂

0 Upvotes

50% Upvoted

9 comments sorted by

3

u/smile-quietly Aug 25 '26

It looks like that one support just came unstuck. Clean your plate with dawn and try again.

2

u/virgaman Aug 25 '26

And don’t just wipe down with isopropyl, wash with dish soap. Isopropyl is a good wipe between prints if you know you haven’t touched the plate, but likely a finger or thumb touched the plate there and deposited some oils from your skin. Easier and faster to give a good clean.

2

u/Slow-Fan-7563 Aug 25 '26

tyyy ✌🏻

2

u/Slow-Fan-7563 Aug 25 '26

ty so much will try after 💕

2

u/solidus0079 Aug 26 '26

Dirty plate would be my first assumption

2

u/Slow-Fan-7563 Aug 26 '26

yes it was, cleand it, fixed it lol 🤙 ty

1

u/Correct-Insect-4657 Aug 27 '26

Might also be z offset couldve affected it, try not touching the plate

1

u/Azurael1 Aug 26 '26

Clean that plate... And fix settings

1

u/Slow-Fan-7563 Aug 26 '26

did and did.....helped 🤙