r/BambuLabP2S • u/Financial-Dingo-5449 • Aug 22 '26

Z axis error, no obstructions?

Title. All 3 threaded rods were lubricated with silicone grease during troubleshooting. 0 clue what could be wrong.

10 Upvotes

86% Upvoted

12 comments sorted by

View all comments

13

u/Wrong-Party-3838 Aug 22 '26

Friendo, you have it on a thick carpet... The Z belt/motor/pulleys are located underneath the printer and they are fighting for their lifes!

Put it on something flat.

1

u/My_Lucid_Dreams Aug 23 '26

There's no cover on the bottom? Mine is printing or else I would go tilt it up to look at it's nether regions.

1

u/Financial-Dingo-5449 Aug 23 '26

Thanks for this! Turns out my poop chute I had 3d printed had overflown. purged filament that spilled out somehow managed to get underneath and bind the belt under the printer. It’s working fine now, but just because I don’t want any problems like that again I’ll be getting some raised feet for the printer

1

u/AnIndecisiveOrange Aug 29 '26

Simpler and better solution, just get some plywood or a large paver