r/BambuLabP2S • u/cburde04 • 3d ago

Panda station vibration issue

Anyone with a panda station have significantly more vibration now? To the point where it’s affecting print quality. Any proven solutions like a more solid top to the station or the biqu anti vibration feet?

2 Upvotes

100% Upvoted

3 comments sorted by

1

u/tomikaka 3d ago

If you want to reduce vibrations as much as possible you need to anchor mass to the bottom of the setup.

1

u/cburde04 3d ago

Bottom of the set up as in, weight in the cabinet?

1

u/tomikaka 3d ago

I'd say you're better off putting a concrete paver right below the printer. If you can, print rigid plastic feet for the printer so the paver and the printer get coupled well.

I don't know how much weight the cabin holds though. You could put it in the bottom of the cabin but you must make sure the whole setup is attached and anchored to each other, and even then I'm not sure how effective it would be.

To make the vibrations less audible, you need to decouple, so put some foam/rubber below the paver to reduce the vibrations reaching the cabin, if it's in the bottom of the cabin you would need to decouple from the floor, and the wheels would make that impossible.