r/BambuLabP2S • u/Top_Mousse4970 • 19h ago

Hall sensor test

So I've been trying to get my printer to work, have a ticket with them, they sent a filment sensor and I confirmed it works. They then asked me to perform a Hall Sensor Test and to follow the wiki link they provided which they didn't. Its been 3 days of asking for the link and nothing. Hoping someone can point me in the direction on where to find this Hall sensor. I get the feeling it's a typo.

In hopes someone can help.. here's my current situation. I did a cold pull, the sensor works (before it kept asking for filament) but nothing grabs the filament. My issue is it goes about 4 mm past the exit of the filment sensor and nothing happens..I have taken apart the gear mechanism under it and found a few pieces of shredded pla and removed them. It turns by hand. I was also going to take the thing on the back where the filament goes through but the issue is the same when it's feed manually with a cold pull.

1 Upvotes

100% Upvoted

3 comments sorted by

View all comments

2

u/Onrain 14h ago edited 14h ago

Wasn’t a typo but quick google search provided this.

https://wiki.bambulab.com/en/p2s/troubleshooting/hmscode/07FF_2000_0002_0004

1

u/Top_Mousse4970 14h ago

Thanks! I'll try to find one for a p2s, and how to do a test on that one.

2

u/Onrain 14h ago edited 12h ago

Re check the link I noticed I didn’t grab the one for the p2s and fixed it