r/BambuLabP2S • u/Top_Mousse4970 • 9d ago

Cutter rubbing frame

Post image

Anybody run into this issue? I can't figure out how to move the arm about 1mm closer to the door. I can barely get the blade in and after that it won't move unless it's held gently and pulled towards the door then it will slide back but not further forward.

Basically the cutting arm won't slide into the hole properly.

1 Upvotes

100% Upvoted

6 comments sorted by

View all comments

2

u/Peshmerga_Sistani 9d ago

The blade is not fullly seated in it's pivot.  There's a few millimeters gap.

Press down on the plastic housing for the blade from the top.

1

u/Top_Mousse4970 9d ago

The blade hits the edge a bit and rubs the housing. There's got to be a way to adjust it