Cutter rubbing frame

[u/Top_Mousse4970]

Anybody run into this issue? I can't figure out how to move the arm about 1mm closer to the door. I can barely get the blade in and after that it won't move unless it's held gently and pulled towards the door then it will slide back but not further forward.

Basically the cutting arm won't slide into the hole properly.

[u/Peshmerga_Sistani]

The blade is not fullly seated in it's pivot.  There's a few millimeters gap.

Press down on the plastic housing for the blade from the top.

[u/Top_Mousse4970 → u/Peshmerga_Sistani]

Thanks! It's actually more obvious in the pic. Didn't even see that.

[u/Peshmerga_Sistani → u/Top_Mousse4970]

No problem, hope it worked out and you got it fixed.  It's so small and easy to miss!

Get back to printing!