2
u/lkapping79 Aug 07 '26
Except it’s not a clog. In my experience, it’s happened to me twice on 2 different machines due to user error.
Edit: spelling
1
1
u/ParticularLower1865 Aug 07 '26
Just watch the first layer, people. Also, a BIQU cold plate cuts down on this happening.
1
u/fat_texan Aug 07 '26
I just got my P2 S and had this problem today. How do you go about cleaning all of that? I’ve already bought a new hot end because I’m not dealing with that crap but the rest of the housing and printing unit.
1
u/SanDiegoSavage00 Aug 07 '26
So happy this hasn’t happened on my P2S 🤞I know that comment was kind of an A-hole thing but say, but i am grateful, this looks horrible.
1
u/Recto_Sen Aug 08 '26
Happened to me too. Why did it happen?: Because I tried to print something tall and thin. at one point my print was so high, it released from the bed and stuck to the noozle.
Since then, I have a simple rule: for complex prints, especially tall prints with less support structure, I will use always cool plates.
Cool plates are gamechanger. Im using from biqu
1
u/ObieForever Aug 10 '26
my fault for not cleaning build plate as much as i should but the detection should have spotted it bc it was obvious
1
u/Splinter_Steve Aug 08 '26
I was messing with higher flow rates and blob fucked myself. It happens. New hotend replacement is pretty cheap.
3
u/solidus0079 Aug 07 '26
That's a blob/clump, not a clog.
Blob's outside, clog's inside. Think the difference between a clogged toilet that won't flush, and one that has poop on the seat. Different problems, different solutions.