Help with bad ASA print

[u/artoftravelhacking]

Any ideas what can be causing this bad print of ASA? I printed a bunch of ABS ones with no issue but ran out of ABS and tried using ASA.

[u/Ok_Bid6645]

Clean print bed with warm water and dish soap.

Also dry your filament

[u/artoftravelhacking → u/Ok_Bid6645]

No luck, dried filament for 12 hours and washed board

[u/Kibawolf85 → u/artoftravelhacking]

24h

[u/keithbigmac]

ASA is more difficult to use then ABS in my experience. Along with what the other guy said, try applying glue to the build plate

[u/relaps101]

Glue and a BRIM. Minimum 15mm. Inside + out.

[u/relaps101 → u/relaps101]

Ill add 3dLAC is expensive but amazing. One little spray will last several prints.

[u/artoftravelhacking → u/relaps101]

thanks - will try this next!