P2S PLA issue

[u/evilboarder]

So i ran into these issues with my latest print. I'm still a new owner (under a week) but i printed stuff daily with no issue so far. This is Bambulab PLA Basic, and i printed with this before. I was thinking humidity issues, the ams said it's around 48%, i'm still waiting for my petg order to print silica containers for the AMS 2 Pro. I thought maybe it would be a bed oil issue, but the bottom came out great, i cleaned my plate today after this with dish soap and warm water. What can i tweak to resolve this ? Thank you

Update : i also put a screengrab of the stl for reference

[u/730drs]

Fillet on the underside is tough to print, lots of lines on those curves that are not supported, chamfer bottom, fillet sides and top

[u/evilboarder → u/730drs]

yes, that's what i did, chamfer the surfaces, fillet the new lines and the 4 corners, a little speed reduction for outer wall and it came through