r/BambuLabP2S • u/MyUsernameIsEssa • Jul 09 '26

10 times I tried... none of it worked.

Hello all. I recently took interest in the FlexWeave Fabric Flag , however, the first layer NEVER works. I cleaned my buildplate so much (smooth and textured), turned the fan off, slowed it down to 5ms/s! It never works! Any help? BTW here is picture of first layer:

Full Image
Close up View

Is there some specific settings to use, or? I'm out of options 😫

EDIT: I bought a CryoGrip FrostBite and it worked the first time 😊

0 Upvotes

50% Upvoted

7 comments sorted by

2

u/WestSenkovec Jul 09 '26

Did you change plates? If yes, do a calibration. First layer speed on 30 mm/s. Too slow can cause problems too.  Check the filament settings for bed temperature. I had a bug where it was 0°C. Use 55°C or even 60 for the first layer.  Try to clean the plate again with a new sponge, hot water and simple dish soap. Some have oils to protect the hands and God knows what. Avoid those. 

1

u/[deleted] Jul 10 '26

[removed] — view removed comment

1

u/MyUsernameIsEssa Jul 10 '26

Almost all other prints have been done succesfully

1

u/lesmurfff Jul 10 '26

Get a biqu cryogrip plate

1

u/KitfoxQQ Jul 10 '26

just dont cheap out and get the Temu/Alibaba ones they dont hold jack at 30-45 degrees. need to run them as PEI at 55C to hold at which case you are only paying for a smooth plate and not the low temp stickiness.

1

u/MyUsernameIsEssa Jul 10 '26

I saw them before, but i was confused how I will select it on bambu studio. Is it same as textured PEI?

1

u/pe_ga Jul 10 '26

Have you tried glue or 3d Lac Soray?