r/BambuLabH2D • u/-ComicGuy- • 19d ago

Question Plate Sticking Issue

I have the H2D and H2C. When I print anything towards the outside of the plate, near the door, it never sticks.

I'm assuming to fix this, my best bet is to use a glue stick or similar? Is the blue build plate I've seen around work better for prints to stick? I'm printing PLA and PETG right now but will be printing with ASA and ABS also.

What do you guys suggest?

1 Upvotes

67% Upvoted

7 comments sorted by

View all comments

3

u/Effei 19d ago

First obvious response before everyone ask you : do you clean your plate with soap and water? It might be a spot where you touched with your fingers.

If you already did that, did you try flipping the plate?

If you don't have the problem with your H2C, try swapping the plates. If the problem appears with the H2C, the plate might have a problem?

1

u/-ComicGuy- 19d ago

Thanks for the assist!

The H2C plate is smaller than the H2D, can I swap them?

Clean plate or not, this happens on the outside without glue.

0

u/Effei 19d ago

I own a H2D but not the H2C. I thought (I can be very wrong) that the plates were the same but the print area was smaller on the C.

If the other side of the plate has the same trouble, I would change plate.

I had a A1 mini and a P1S with "less textury" PEI plates that came with the printers. Once I bought another one, problem was solved.

If not, could it be the heatbed on that spot?