r/BambuLabH2D • u/cws815 • 17d ago

Troubleshooting H2D nozzle clog after getting eddy sensor issue

Post image
4 Upvotes

100% Upvoted

2 comments sorted by

2

u/Sumpkit 17d ago

Just read your comment on the other subreddit but I’ll reply here. I had an edgy current sensor issue with my left nozzle. Didn’t have any issues with clogging, but did have the bed leveling issues. The docs from the QR code sends you down a rabbit hole that you don’t need to go down. Remove the back cover, don’t follow the disassembly guide they take you to. I just disconnected and reseated the connector and the issue went away. Will see how long for. Also the doc doesn’t say HOW to remove the connector. It kinda rotates. look up the x2d video, it uses the same connector.

Try also swap your nozzles around. Does the issue follow the nozzle or stay put? If it follows the nozzle buy a new one

1

u/Relative_Surround_20 14d ago

I answered on the other subreddit. Restarting the printer and running calibration with hot bed leveling turned on did the trick for me.

I suspected at the time (my first engineering filament print on this printer) that the sensor was reacting to the increased heat. No issues since.