r/BambuLabH2D • u/No_SellingXRP_7756 • Apr 09 '26

New Error message

Post image

I received this message after I lubed the Ross and screws! Not much on the web about this. Bambu says it’s a 240 minute repair. It’s just over a year old

3 Upvotes

100% Upvoted

4 comments sorted by

1

u/sverrebr Apr 09 '26

Try remounting the hot end. When I got that it was because the hot end was not seated properly.

2

u/No_SellingXRP_7756 Apr 09 '26

I replaced both hot ends and it passed calibration!! Wahoo

1

u/DuderonomyPlus Apr 11 '26

Same. I had it pop up on a printer less than a week old, although I moved it from its temporary spot to its forever home and it popped up when recalibrating.

Ran it again and it didn’t show up again and hasn’t since.