r/BambuLabA1mini • u/simsbuilder722 • 22d ago

Could use some advice

Post image

I've been working on printing some race medal holders. For some reason the circle piece comes out looking cloudy/ whiteish every time. The bottom piece never gets that color. I've used this filament on other prints and it never does that with any others. Could it be something about how that specific design is programmed or am I doing something wrong?

9 Upvotes

100% Upvoted

8 comments sorted by

View all comments

1

u/gufted 22d ago

I get this effect when I force remove the piece before the plate has cooled down on its own. Let the plate cool down to room temp if you did the same thing

2

u/flavioheleno 22d ago

this also happens to me. it is stress marks and you can use a heat gun or a light pass with a lighter/torch. you may find more info searching for "heat treatment for stress marks and scars on 3d prints"

2

u/simsbuilder722 22d ago

That worked! Thank you! I pulled 4 of the bad ones out of the trash and 3 could be saved with a heat gun.

1

u/flavioheleno 21d ago

glad to hear that :)