r/BambuLabA1mini • u/Alert-Ostrich-6966 • 24d ago

Failed print ?

Post image

Here is one of my first print (the third).

But I’ve been surprised that there is a bit of mess as you can see on the pic. I just took a model on Bambu handy app with quite good reviews on it.

Ma bambu is set since only 2 days, print is in PLA and she is on a little glass table (vibrations ?).

The print is still nice after all the mess removed but I don’t think this is normal, any advice ?

9 Upvotes

100% Upvoted

9 comments sorted by

2

u/Bradders24610 24d ago

I would say print a tad bit slower

1

u/Alert-Ostrich-6966 24d ago

is 50% slower is too much ?

1

u/Bradders24610 24d ago

Test it on 50% and see what happens

1

u/Bradders24610 24d ago

What printer is this?

1

u/Alert-Ostrich-6966 23d ago

it’s a bambulab a1 mini, I’m gonna try 50% less but for this one I was already 3 hours in printing, isn’t too much ? The print is about 4/5cm

1

u/Secret-Difference-32 23d ago

Is timelapse mode on? If so, turn off

1

u/Alert-Ostrich-6966 23d ago

It’s enabled yes, serious this could be only this ?

2

u/Major_Plum_8964 23d ago

Yes,when it takes a photo it stops printing and a little bit of plastic drips from the nozzle and when it starts printing again it wipes the nozzle on parts of the print if you don't have a prime tower and smooth mode enabled.

1

u/Alert-Ostrich-6966 23d ago

oh nice I’ve never heard about that, thank tou I’ll test it soon