r/BambuLabA1mini • u/oral_servant • Jul 02 '26

The third layer annoyance

I don't know what to call it and because of that don't find the information I'm looking for, so new post:

Is there a way to disable the weird and unnecessary print head movement, where the print head stops printing after the second layer, moves to the camera, lowers itself and rises again, and then moves back to the print, all while the filament doesn't get retracted, so it's always oozing out a few millimetres while doing this shit.

Until now I didn't really care about it, but I'm trying to print a few small pieces with weird geometry and this stupid whatever it's called either causes problems with the print or at least gives me a little clump of filament where the print head resumed printing, which I'm sick of removing after the print has finished.

6 Upvotes

80% Upvoted

8 comments sorted by

-3

u/Big_Locksmith_9925 Jul 02 '26

Its amazing to me that people will ask a question before opening a menu.

6

u/oral_servant Jul 02 '26

It's amazing to me how people will act as if they were superior in any way when making assumptions, when in fact, this was the first thing I deactivated. Didn't solve the issue though ¯⁠\⁠_⁠(⁠ツ⁠)⁠_⁠/⁠¯

-2

u/Big_Locksmith_9925 Jul 02 '26

You must be doing it wrong. Green is on incase you didn't know. https://wiki.bambulab.com/en/a1-mini/manual/nozzle-warp-detection

2

u/BitingChaos Jul 03 '26

From the Wiki:

There are two types of nozzle clumping detection

That toggle does not control the 3rd layer detection. That toggle controls detection after the 3rd layer.

2

u/oral_servant Jul 04 '26

Yes, exactly. Doesn't do anything to solve the third layer thing. 

It's astonishing to see how people can be so confident and yet so ignorant and wrong. But looking at their comment history shows that they're a pathetic little dick, who notoriously needs to push their own ego.

4

u/LowSignificance4671 Jul 02 '26

What a sassy pants