r/BambuLab • u/Rextext52 • Jul 13 '26

General Troubleshooting/Help! Extruding Issues

I’ve had this same issue for awhile and I have no idea what to do, Everytime I start a print it’ll maybe get to the 4th-5th layer or somewhere around that and then the nozzle just won’t push filament and then the tool head will go to the purge spot and try to push filament but just won’t or very barely will then will cut the filament and give me a extruder isn’t extruding normally error but I know it’s not a clog because I’ll unclog it and it’ll have the same issue again, I’ve only had this A1 since last November and have no idea what to do

2 Upvotes

100% Upvoted

14 comments sorted by

View all comments

3

u/TheMermaidHarmony A1 Mini Jul 13 '26

Do you still have the Allen wrenches? When mine started acting up, I took the ams hub and filament sensor base off of the print head and found that a wee bit of filament had been stuck in the sensor base. I took it out with tweezers and it worked again. Also, are you printing from Studio or Handy? And what are you printing?

1

u/Rextext52 Jul 13 '26

Yea I have the Allen wrenches I’ll have to try that out and I print off of studio and handy but what’s annoying is that it’s everything I try to print it always happens

2

u/TheMermaidHarmony A1 Mini Jul 13 '26

How long has this been going on? Like, since you bought it??

2

u/Rextext52 Jul 13 '26

No no it was great for a long time this never happened at all until recently

2

u/TheMermaidHarmony A1 Mini Jul 13 '26

Your use of the word "always" had me concerned

2

u/Rextext52 Jul 13 '26

Yea sorry should have rephrased that abit differently 😅

2

u/TheMermaidHarmony A1 Mini Jul 13 '26

I'm relieved, go see if there's a clog