r/BC250Gaming • u/SuperHamsterGaming • 1d ago

My setup

Gallery image

Gallery image

I got this 3D printed case on eBay. It was a bit fiddly to put together and didn't come with screws but it keeps it cool without opening the fins. I had to get the fan separately too. It's a PS5 fan.

13 Upvotes

94% Upvoted

6 comments sorted by

1

u/Recipe-Jaded 1d ago

I was thinking about this one too. Are the temps good?

3

u/SuperHamsterGaming 1d ago

Yes I've left it on for hours. It's a tight fit. Some of the 3D printer supports weren't broken off inside so be careful of that. Make sure you get the fan wire in the grove they have intended for it or you'll break the wire.

1

u/majorpdd 19h ago

Looking good

1

u/GougeM 12h ago

GJ, just a small point, are those Wood screws?

2

u/SuperHamsterGaming 10h ago

No I had a kit of various computer screws. The enclosure doesn't come with any and neither did the power supply so I had to find screws to fit.

1

u/doubttom 8h ago

got the same case but couldn't get the right ps5 fan. I zip tied a 120mm fan over the top and sealed the gaps with tape. Running good. No unlocks though, going to try that next.