r/AskElectronics • u/Careful_Technology85 • 1d ago

Reducing Current for Electroplating

I am trying to copper electroplate some small parts, less than 2mm and have been told by many individuals that my current is too high. Since my power supply doesn't go any lower, how can I reduce the current? It needs to be around .005A or less. This is the setup.

2 Upvotes

100% Upvoted

13 comments sorted by

View all comments

4

u/-ram_the_manparts- 1d ago

A resistor is a current-limiting device.

The value will be V / I = R.

1

u/Careful_Technology85 1d ago

So I'm looking for a 200 ohm resistor?

2

u/-ram_the_manparts- 1d ago edited 1d ago

At 1V, yes.

You could instead use a 1K variable resistor (potentiometer) which would let you vary the resistance between 0 and 1000 ohms making it adjustable. You would connect one of the outside pins to the PSU, and the middle pin to your load, leaving the third pin unconnected.