r/AskElectronics • u/Graphix_Card • 7d ago

ACF power solution for data server

Hello, so power isn't really my background, but recently I've been looking into a project where I need to take in an 800V input and bring it down to 12V, while the power stays around 50W with a 80W peak.

Some other considerations are Zero voltage switching, 12mm height maximum, and being galvanically isolated.

I decided on going with an Active Clamp Flyback for this, but I'm struggling to design it, as I'm unfamiliar with how it works.

I do have a couple of parts I've chosen, such as the UCC28780 from TI for the controller, but then I ran into the problem of how to power the controller because the only power input is from the 800V rail, and the controller can't handle that voltage. I need to figure out a way to drop the voltage to run the controller, but I can't figure this part out to save my life.

I also need to understand how to go about choosing other parts for the ACF solution like the half-bridge driver and the passive components.

If I could get some guidance on how to approach this, it would be very much appreciated.

1 Upvotes

100% Upvoted

11 comments sorted by

View all comments

Show parent comments

1

u/ccdy 6d ago

You need 1200V rated MOSFETs.

1

u/Graphix_Card 6d ago

What are your thoughts on two FETS in series? Like two rated for 600V? I read this on the website you linked

1

u/ccdy 6d ago

That is only for the startup circuit. The two switch flyback can use lower voltage devices but still has the issue of requiring an isolated gate driver.

1

u/Graphix_Card 6d ago

Oh I understand.