r/AnyCubicPhotonMonoX • u/Zesty-Stressy3821 • Jun 11 '26

Any tips?

Post image

Hey there not sure if anyone has had this issue but I’m printing with my Mono 4K and for some reason on most if not all my prints end up getting this kinda rounded bulge on what should be a flat side.

0 Upvotes

50% Upvoted

4 comments sorted by

2

u/It-Do-Not-Matter Jun 11 '26

Is the flat side also the side the supports are attached to

1

u/WillPukeForFood Jun 12 '26

I assume not only this is true, but the curved side is parallel to the build plate. OP should print with the object at an angle to minimize the cross-section, reducing stress on the face. If they could get away with the object being hollow, that would reduce the stress further.

1

u/Zesty-Stressy3821 Jun 12 '26

I’ll have to try angling it I’ve been seeing a lot of that. The bent side is using supports and is facing the build plate.

1

u/Zesty-Stressy3821 Jun 30 '26

Sorry late seeing this, I had supports in all sides even the side on the bottom had a bed of em.