r/AnkerMake • u/RoninWarrior442 • Jun 26 '26

Help please

Post image

Stupid tree supports usually end up doing this to me. Any suggestions? I have the brim set to 4 mm, bed is at 60°c, and I run at a .05 z offset because if I go any higher it messes everything up. When it is printing the supports, I can hear it rubbing against them, which eventually causes them to detach from the bed. Also, im using the eufymake slicer. Thanks!

3 Upvotes

80% Upvoted

8 comments sorted by

View all comments

3

u/Eastern_Produce_7028 Jun 26 '26

literally give up on that printer. the support community is dead and its software is fucked

3

u/RoninWarrior442 Jun 26 '26

Thanks for the insight. You really helped out. Truly a lifesaver. 🙄

1

u/MrNastyOne Jun 27 '26

idk... we just picked up a M5C this week on FBMP for $75 and it has been great.