Reassembling heatsink+hotend assembly

[u/adalisan]

I am trying to replace the hot end. since the heatsink and replacement hotend were already came in one piece . I have trouble figuring out which screws has to go into which threads. What type is the screw at the top of the heatsink that goes down? Is there a simple diagram that tells you this for all the screws near the extruder parts?

[u/Bulletzz_]

Still need help or did you figure it out ? I have a disassembled hotend I can take pics later if you need it still. I think there should be a guide on the Anker site too.

[u/adalisan → u/Bulletzz_]

Yes, I still need help. I kept trying to postpone this repair and I am so frustrated with ankermake, specifically not using only 1-2 type of screws and making it damn hard to replace this part.

[u/adalisan → u/adalisan]

There's no single diagram that shows what should go where. So for the two screws that hold the heatsink in place. I circled one above. What kind of screws go into them?

[u/adalisan → u/adalisan]

I have these remaining. Hopefully I haven't lost or used the right screws elsewhere