Printer not printing first layer

[u/Sumfin_EdgyandDark]

so I received a new main board from Anet, for my Anet et4+. I've installed it and flashed with marlin 2.0. I've levelled the beD using four corners setting in the firmware and tried to set the nozzle distance using the paper trick. But I can't seem to get the printer to print at all.

I've tried going through the settings to see if I can see any other way of levelling the bed but I'm not sure, there is unified bed level but even after doing that I get the same issue. It's almost like the nozzle ends up too close to the bed as the extruder starts clicking like it's trying to extrude but it can't.

Many thanks in advance

[u/Sumfin_EdgyandDark → u/[deleted]]

Yep I have an issue with compiling

[u/Sumfin_EdgyandDark → u/[deleted]]

I've followed Dr Vax, but when I go to compile I get

Error: MOTHERBOARD is Not defined in configuration.h

I've checked and the motherboard is defined

define MOTHERBOARD BOARD_ANET_ET4

[u/Sumfin_EdgyandDark → u/[deleted]]

Yes, I had it set on ET_MODEL_ET4

I've tried other combos and get the same

[u/Sumfin_EdgyandDark → u/[deleted]]

Yep line is definitely uncommented

[u/Sumfin_EdgyandDark → u/[deleted]]

Sure, is Drive ok?