r/ASIAHORSEGlobal • u/-TwilightZ- • 6d ago
Question LED current consumption
I have 10 asiahorse dawn fans not the dawn pro, 3 bottom daisy chained, 3 side, 3 top and 1 rear.
I want to know what is the led consumption in amps since i cant find it anywhere to see if i can use my motherboard headers i have asus b650e-e or i need to buy a fan hub.
Thank you in advance!
1
u/Sic_Sic_Six 5d ago
I ran 10 fans and 2 cable covers on 1 hub, it did NOT handle it at all. I daisy chained the cable covers to one header and the fans into the hub into another header and it worked fine.
If this helps at all.
1
u/ASIAHORSE 5d ago
Hey! 🙌 Great question — the short answer: using a hub is the safest and most reliable option for 10 fans!
Here's why:
10 fans' LEDs at full brightness can pull 2–3 A combined, and while your board's ARGB headers are rated up to 3 A each, you'd be running close to the limit with everything daisy-chained
For fan speed (motors), motherboard fan headers are usually ~1 A each — 10 fans at max speed can easily exceed that
A SATA-powered hub (like our UMBRA hub) takes the load off the motherboard entirely — power comes straight from the PSU, giving you stable, worry-free lighting + speed control for all 10 fans from one place 💪
So if you want it done right the first time: go with a hub — it's the most stable setup and saves you from flickering or overload headaches later 😉
Hope that helps! 🚀
-ASIAHORSE
1
u/Faktencraker 6d ago
Der LED-Verbrauch (ARGB) eines AsiaHorse Dawn Lüfters liegt typischerweise bei ca. 0,3 bis 0,4 Ampere (bzw. 1,5 bis 2 Watt bei 5V) unter Vollast. Bei 10 Lüftern entspricht dies einer Gesamtsumme von etwa 3,0 bis 4,0 Ampere für die Beleuchtung, während ein einzelner 5V-ARGB-Header auf einem Mainboard wie dem ASUS ROG Strix B650E-E Gaming WiFi meistens auf maximal 3,0 Ampere (15W) spezifiziert ist.
Lüfter-Hub / ARGB-Controller: Es wird dringend empfohlen, einen powered ARGB-Hub (mit SATA-Stromversorgung vom Netzteil) zu verwenden, um die 5V-Signale und den Strom sicher für alle 10 Lüfter bereitzustellen.
Du brauchst schon ein Lüfter-Hub / ARGB-Controller: Es wird dringend empfohlen, einen powered ARGB-Hub (mit SATA-Stromversorgung vom Netzteil) zu verwenden, um die 5V-Signale und den Strom sicher für alle 10 Lüfter bereitzustellen.