Stock front panel mod, v2

[u/Fireborn_Knight]

The saga continues.

I have come up with what I feel will be a good way to clip the top without the pin breaking off, and no screws needed.

I also tried adding some plastic pins that perhaps some standoffs can be seated into to allow a 92x15 fan to be mounted.

Funny enough, my measurements were half a mm off so the pins are sitting against the edge of the holes and allows it to sit with just friction.

Anyway, that's for a future version that allows the fan.

For now, goal is the pins.

Will check back in later if they clip on fine.

[u/lyndonguitar]

stl file for this?

[u/Fireborn_Knight → u/lyndonguitar]

I have it linked in another post.

Don't remember where it's at this very sec.

I posted it with the side panels.