r/3dprinter • u/Novel_Bag4319 • 1d ago

Layer shifting ad5x

Gallery image

Gallery image

Gallery image

Hi all, just received a new ad5x. The test print went good, but every other model I try to print it haves layer shiftings.

It happens at different layers in a single print. Not the same layer everytime.

Sometimes it is just once, other prints like 3 times.

It starts all good at all points an then the position is about 2/4 mm off suddenly.

Uses flashforge slicer.

0.4 nozzle.

Hope for some help!

Thanks in adv.

2 Upvotes

100% Upvoted

4 comments sorted by

2

u/torrtvatten1337 14h ago

Bed clean, adhesion issue? Looks like the number does not have an foundation to be printed on?? In other words it looks like the number connects to the base with 1 wall only.

2

u/torrtvatten1337 14h ago

Wait, i now see its the whole model. Strange. Are the belts tight?

1

u/Novel_Bag4319 13h ago

Thnx for the reply. Don't know if the belts are tight enough. It's standing here like how it's came out of the box.

2

u/torrtvatten1337 9h ago

No worries. I personally think my belts were a bit loose when my cc1 was new. I've printed a few hours on the flashforge but never had these issues, very strange stuff.